NVIDIA has published a walkthrough showing developers how to build a robot pick-and-place simulation in Isaac Sim using assets from SimReady Central, an open asset library on Hugging Face. The example pairs a UR17G robot arm and Robotiq 2F-140 gripper with a beverage can, with the task of grasping the can, lifting it, moving it to a target and releasing it. An AI agent, which the example runs with GPT-6 Sol, is used to generate and execute the task code. The authors warn that generated code and results can vary, so users should inspect the code and check the behavior before adapting it. The guide describes a SimReady asset as an OpenUSD file prepared with the properties a particular simulation needs, such as collisions, mass, joints and joint drives. Validation reports for the arm (checked against the Robot-Body 4.0.0 profile) and the gripper (Robot-Gripper 3.0.0) both record passing PhysX driven-joint checks. Before running a pick-and-place task, the authors recommend reviewing joint limits and drive settings, testing small arm movements and gripper open and close actions, and confirming that the can rests on the work surface without falling through. They also advise watching whether the can stays in the gripper during motion. Because asset structures vary, the settings in the loaded scene are the starting point. The workflow requires Isaac Sim 6.2, an agent that can use Isaac Sim skills, and the Hugging Face CLI if assets are downloaded from the command line. Users are told to keep each downloaded asset folder intact and give the agent local USD file paths. The piece is a technical how-to aimed at robotics developers and researchers rather than a consumer product announcement. For most Australian businesses and professionals, this changes little immediately. It is most relevant to robotics, manufacturing and research teams that test simulations before deploying physical robots, where pre-run checks could reduce the risk of costly errors on real hardware. The article does not disclose licensing or hardware costs, so teams should check Isaac Sim's system requirements and licence terms before committing. The walkthrough involves no personal data, so it does not by itself trigger obligations under the Privacy Act 1988, though any later project that handles personal information would need its own assessment. It is worth trying only if you already run robotics or simulation work.